How do I setup a uDynamo card reader?

     The Magtek uDynamo card reader allows you to accept credit card payments by connecting the reader to the audio jack on your iPad. 

To start using the uDynamo card reader, go through the following steps:

Step 1 :  Go to the "Settings" tab in the admin panel and select "Card Swiper Type"

Step 2 : Then change the "Card Swiper Type" to "uDynamo (Audio Jack Connector)"

Step 3 : Plug in the uDynamo into the audio jack of your iPad.  Make sure your uDynamo is fully charged and the audio on your iPad is turned up all the way to the maximum volume.

*Note* The first time you run a credit card transaction, talech will ask you to enable the "Microphone" settings. You must allow the Microphone settings or your card swiper will not work.