This guide will take you through the setup of your Moby Smart Stand. Before you begin, make sure that you have all the necessary parts needed to assemble your stand.
- The Moby Stand does not have its own Power Cable. It utilizes the charging cable that comes with the Moby devices itself.
Additionally, we now have a new USB printer that will ONLY work with the Moby Smart Stand. This printer does NOT function with the Moby C150. See info here:
- The printer model is TSP650 USB interface (TSP654IIU)
The Smart Stand also supports the following peripherals:
Tools needed :
- Sunglasses sized screwdriver size 00
Parts of stand needed:
Step 1. Place stand into the base.
Step 2. Screw the stand into the base of the Moby using the 4 folding D-wing bolts.
|Connect Mounting Clip To Moby|
Important Step: If the Moby tablet has an Ingenico sticker on the back of the Moby, peel off the sticker to reveal the screw holes.
Step 1. Alight the mounting clip with the screw holes on the back of the Moby
Step 2. Screw in the mounting plate by using the 5 small 00 size screws to the Moby
|Connect Moby to Stand|
Step 1. Remove the stabilization clip, adjust it to your preference before sliding the Moby into the stand. Insert the stabilization clip to securely hold the Moby device in the Smart Stand.
Step 2. Rotate the Moby to the desired orientation. portrait or landscape
Step 3. Insert stabilizing clip in-between the Moby and the stand. to secure the Moby in place