This article below will provide you step by step instructions on "How to Install talech Register" onto your Moby Device.
Table of Contents:
- Steps Before you being
- Download & Install the talech register
- Allow App Permissions
|Before you begin|
Make sure that your Moby has an active Internet Connection to download the talech app. This is typically completed during the initial Moby Setup
To connect to your WiFi follow the Step by Step instructions below.
Step 1. Go to Settings > WiFi > Select your Network > Enter Password (if required)
To Allow Installation from Unknown Apps follow the instructions below.
Step 2. Go to Settings > Apps & Notifications > Chrome > Install Unknown Apps > Enable "Allo from this Source"
Screenshot below to reference.
Download & Install the talech register
In this section of the article you can follow the Step by Step Instructions on "How to install talech register onto your Moby Device.
Step 1. Launch the Chrome Browser on the Moby Device then reference the relevant link to complete the talech Register installation.
Step 2. talech register installation links below
Click here and follow the prompts to install talech Register for talech Direct or IMS gateway customers.
Click here and follow the prompts to install talech Register for Elavon customers:
Allow App Permissions
After installing the talech Register Application for the first time. There will multiple prompts that are required to run the application effectively. The Register requires access to the following permissions:
The above can be enabled through the Moby's settings. To do so, follow these steps
1. Find the Settings application on the Moby Device (this is outside of the talech Register application).
2. Select Apps & Notification
3. Tap on App Info.
4. Locate and Select Register "talech"
5. Choose Permissions
5. Enable Location, Microphone, Phone, SMS, and Storage by tapping the Grey slider on the right hand side. If the slider is green, then it is already enabled.
After enabling the following permissions, press the Back button in the top left corner. For the new permissions to take effect, press Force Stop in the top right corner. The next time you open the app, the permissions have been activated.