Star Micronics TSP100 Setup
Introduction: This article will guide you through setting up your Star Micronics TSP100 printer with your talech register.
Before you get started, please make sure that you have the following:
- You have all the required components to set up your printer.
- Please refer to the guide, TSP100 Printer Details, for more information
- Your network matches Talech’s requirements to set up the printer.
- Reference talech Network Requirements Click HERE
This article applies to any with the following criteria:
Register Type |
Region |
Talech Tier |
Business Type |
|
|
|
|
Table of Contents:
- Star Micronics TSP100 Printer setup
- Setup in Talech
Star Micronics TSP100 Printer Setup
This section will take you to step by step in setting up your Star Micronics TSP100 Printer.
Step 1: Unpack your Star Micronics TSP100 Printer
Step 2: Insert the paper roll into the Printer.
Step 3: Connect the ethernet/LAN cable into the back of the printer.
Step 4: Connect the other end of the Ethernet/LAN cable to an available network point near the location where the printer will be located.
Step 5: Power on the printer by pressing the power switch, which is located on the left-hand side of the printer.
Step 6: Wait until your printer shows a steady green Ready status light and no Error light
How to obtain the IP Address from your Star Micronics.
Step 1: Turn Off Printer
Step 2: Hold Feed Button
Step 3: Turn the Printer back On
Step 4: Hold Feed Button for 2 secs and Grab the IP address.
Setup in Talech
Now that your printer is connected to your network, you can continue the setup of the printer in the talech app by following the link below, which corresponds to your Register device type:
Comments
0 comments
Please sign in to leave a comment.