Star Micronics TSP650ii Setup
Introduction: This helpful article will guide you through setting up your Star Micronics TSP650ii printer with your talech register.
This article applies to any with the following criteria:
Register Type |
Region |
Talech Tier |
Business Type |
|
|
|
|
Table of Contents:
- Star Micronics TSP650ii Printer Setup
- Setup in talech
Prepare Printer
This section will guide you through a step by step process in setting up your Star Micronics TSP650ii Printer.
Step 1: Unpack the Star Micronics TSP650ii Printer from the box
Step 2: Insert the paper roll into the printer.
Step 3: Connect the power cable into the back of the printer, and connect this to an outlet that is quite close to where the talech Register is setup.
Step 4: Power on the printer by pressing the power switch. This is located on the left hand side of the printer.
Step 5: Wait a few moments until the printer shows a steady, Green Ready status light and no Error light.
Step 6: Find the Red pair button on your printer, and the small Green light, on the back of the printer near the power connector.
Step 7: You should then hold the Red pair button down for seven seconds and the small Green light will then start blinking.
Step 8: While the light is blinking, tap into the Bluetooth settings on the iPad that you want to connect the printer to. Under > Other Devices > select Star Micronics.
Step 9: Once this is selected, the printer should now connect to the iPad and you will see a Connected message beside Star Micronics.
Setup in Talech
Now that your printer is connected, you can now continue the setup of the printer in the talech app by following the link below, that matches up with your talech Register device type:
How to connect your printer to Talech using an iPad
Comments
0 comments
Article is closed for comments.