Star Micronics mPOP Setup
Introduction: This article will guide you through setting up your Star Micronics mPOP, for use with your talech register.
Before you get started, please make sure that you have the following:
- You have the required components for your Star Micronics mPOP
- Your network matches talech requirements to set up your Star Micronics mPOP
- Reference talech Network Requirements Click HERE
This article applies to any with the following criteria:
Register Type |
Region |
Talech Tier |
Business Type |
|
|
|
|
Star Micronics mPOP Setup
This section will provide step by step instructions on How to setup your Star Micronics mPoP device.
Step 1: Unpack the Star Micronics mPOP
Step 2: Connect the power cable into the bottom of the unit, using the built in cable routing pins so the cable comes out the side.
Step 3: Power on the Star Micronics mPOP unit. The power button can be found on the right hand side near where the cable exits.
Step 4: Insert the paper roll into the receipt printer.
Step 5: Access the Bluetooth Settings on the iPad you wish to connect the Start Micronics mPOP too and ensure it is enabled.
Note: Under "Other Devices" Select the device listed as STAR mPOP-xxxxx.
Step 6: Once the Device is selected, the printer should now connect to the iPad and you will see a Connected message beside STAR mPOP-xxxxx
Comments
0 comments
Article is closed for comments.