ELO Touch Paypoint Setup
Introduction: This article will guide you through setting up your ELO Touch Paypoint, for use with your talech register.
Before you get started, please make sure that you have the following:
- You have the required components for your ELO Touch Paypoint.
- Your network matches talech requirements to set up your ELO Touch Paypoint.
- Reference talech Network Requirements Click HERE
This article applies to any with the following criteria:
Register Type |
Region |
talech Tier |
Business Type |
|
|
|
|
ELO Touch Paypoint Setup.
This section will provide a step by step instructions on How to setup your ELO Touch Paypoint.
Step 1: Unpack the ELO Touch Paypoint
Step 2: The ELO Touch Paypoint comes with two interchangeable Docks, depending on your iPad size and connector type.
Step 3: Simply unscrew the attached Dock and screw in the other Dock, if required.
Note: If the Dock does not need to be changed, please proceed to the next step.
Step 4: Connect the power cable into the port on the bottom of the station.
Note: While there are other ports on the station, these are Not used in talech. Only the power port is used.
Step 5: Insert the iPad in the Dock at the top. On the right hand side there will be a small latch that connects to the iPad’s Power Port.
Push this in until you hear a light snap. You can then screw in the latch to lock it in place.
Step 6: If the iPad is successfully detected, the Feed light should turn from Red to White
Step 7: Tilt back the Dock on the station and insert the paper roll into the printer.
Comments
0 comments
Article is closed for comments.