Poynt 5 Setup
Introduction: This article will guide you through setting up your Poynt 5, for use with your talech register.
Before you get started, please make sure that you have the following:
- You have the required components for your Poynt 5
- Your network matches talech requirements to set up your Poynt 5
- Reference talech Network Requirements Click HERE
This article applies to any with the following criteria:
Register Type |
Region |
Talech Tier |
Business Type |
|
|
|
|
Table of Content:
- Poynt 5 Setup
Poynt 5 Setup.
This section will provide step by step instructions on How to Setup your Poynt 5 Device.
Step 1: Unpack your Poynt 5
Step 2: Make sure that the Poynt device is charged. You can connect the provided USB-C cable into the bottom on the Poynt to charge it, if needed.
Step 3: Power on your Poynt 5 device by holding up on the Power slider for 3-6 seconds.
Note: The power slider can be found on the right side of the unit.
Step 4: Connect to Wifi once the Poynt is Powered ON. You can connect to your Wifi connect by pulling down the navbar from the top of the screen.
Step 5: Select WiFi.
Step 6: Tap your Wifi name and then enter the Wifi password
Step 7: Select Connect.
Once the Poynt is connected to your Wifi, you can select the talech Register app icon to sign into and begin using the system.
Comments
0 comments
Article is closed for comments.