Socket CHS Barcode Scanner - Set up
Introduction: This article will guide you through setting up your Socket CHS Barcode Scanner, for the ability to use with your talech Register.
Before proceeding, please make sure that you have the following:
- You have the required components for your Socket CHS Barcode Scanner
- Please see the Socket CHS Barcode Scanner page for more information.
This article applies to any with the following criteria:
Register Type |
Region |
Talech Tier |
Business Type |
|
|
|
|
Table of Contents:
- Prepare your Socket CHS Barcode Scanner
- Connecting the Scanner to the iPad
Prepare your Socket CHS Barcode Scanner:
This section will provide step by step instructions on How to set up your Socket CHS Barcode Scanner.
Step 1: Unpack your Socket CHS Barcode Scanner.
Step 2: Unlock the battery enclosure by turning the lock to a horizontal position with a thin coin or a flat head screwdriver.
Step 3: Lift up the back and insert the batteries that came with the scanner and re-lock the battery enclosure.
Note: Charge the scanner for 5 hours with the wall adapter charger. The light on the scanner will turn green once it's done.
Connecting the Scanner:
This section will provide a step by step guide in How to connect the Socket CHS Mobile Scanner.
Step 1: Power the Scanner on by holding the small power button above the scanner's silver logo.
Note: The Scanner should beep and a Green Light will appear on top. The scanner will automatically enter pairing mode.
Step 2: Select iPad Settings from the iPad
Step 3: Select Bluetooth Settings.
Step 4: Look for Socket CHS ###### under Other Devices and tap on it.
Step 5: The Scanner should then move to Devices and show Connected.
It is now ready to use in Talech
Comments
0 comments
Article is closed for comments.