Star Micronics SP700 Setup
Introduction: This article will guide you through setting up your Star Micronics SP700 printer, with your talech register.
Before you get started, please make sure that you have the following:
- You have all the required components to setup your printer
- Your network matches talech’s requirements to setup the printer.
- Reference talech Network Requirements Click HERE
This article applies to any with the following criteria:
Table of Contents:
- SP700 Printer Setup
- Setup in talech
Star Micronics SP700 Printer Setup
This section will take you step by step in setting up your Star Micronics SP700 Printer.
Step 1: Unpack your Star Micronics SP700 Printer
Step 2: Insert the paper roll into the Printer.
Step 3: Insert the ink ribbon into the Printer.
Step 4: Connect the ethernet/LAN cable into the back of the printer.
Step 5: Connect the other end of the ethernet/LAN cable to an available network point near the location where the printer will be located.
Step 6: Power on the printer by pressing the power switch, which is located on the left hand side of the printer.
Step 7: Wait until your printer shows a steady green Ready status light and no Error light
Setup in Talech
Now that your printer is connected to your network, you can continue the setup of the printer in the talech app by following the link below, that corresponds to your Register device type: