Epson TM-U220b and TM-T88v-i Printer Setup
Introduction: This article will guide you through setting up your Epson TM U220b and TM-T88v-i Printer, with your talech register.
Before you get started, please make sure that you have the following:
- You have all the required components to set up your printer.
- Your network matches talech’s requirements to setup the printer.
- Reference talech Network Requirements Click HERE
This article applies to any with the following criteria:
Register Type |
Region |
Talech Tier |
Business Type |
|
|
|
|
Table of Contents:
- Epson TM-U220b and TM-T88v-i Printer Setup
- Setup in talech
Epson TM U220b or TM-T88v-i Printer Setup
This section will guide you step by step on How to setup your Epson TM-U220b or for a TM-T88v-i Printer.
Step 1: Unpack your Epson TM-U220b or your TM-T88v-i Printer
Step 2: Insert the paper roll into the Printer
Step 3: Insert the ink ribbon into the Printer
Step 4: Connect the ethernet/LAN cable into the back of the Epson TM-U220b or TM-T88v-i Printer.
Step 5: Connect the other end of the ethernet/LAN cable to an available network point near the location where the printer will be situated.
Step 6: Connect the power cable into the back of the printer, and connect to an outlet in the location you want to set it up in.
Step 7: Power on the Epson TM-U220b or your TM-T88v-i Printer by pressing the power switch, which is located on the front of the printer, into the on position
Step 8: Wait until your printer shows a steady Power status light and no Error light.
Setup in Talech
Now that your printer is connected to your Network, you can continue the setup of the Epson TM-U220b or TM-T88v-i Printer in talech by following the link below, that corresponds to your Register device type:
Comments
0 comments
Article is closed for comments.