Poynt P61 Setup Guide

Poynt P61 Setup

Introduction: This article will guide you through setting up your Poynt P61, for use with your talech Register. 

Before you get started, please make sure that you have the following: 

• You have the required components for your Poynt P61
• Your network matches talech requirements to set up your Poynt P61
• Reference talech Network Requirements Click HERE

This article applies to any with the following criteria:

Table of Contents: 

• Poynt 61 Setup Instructions.

Poynt P61 Setup

This section will take you through step by step instructions on How to Setup your Poynt P61. 

Step 1:  Unpack your Poynt P61

Step 2: Make sure that the Poynt device is charged. Slot the Poynt into the provided dock and connect the power cable into the dock.

Note:  You can also connect the power cable directly into the side of the Poynt device.

Step 3: Insert the paper roll into the front of the Poynt device

Step 4: Power on the Poynt device by holding the power button, located on the underside of the unit, for 3 seconds.

Step 5: Once the Poynt finishes powering on, Connect the device to your Wifi connection. You can do this by Pulling Down the Navbar from the top of the screen.

Step 6: Select the WiFi button.

Step 7:  Tap your Wifi name and then enter the Wifi password 

Step 8: Select Connect.

Once the Poynt is connected to your Wifi, you can select the talech Register app icon to sign into and begin using the system.