Setting up your Sum Up Air reader in talech
Introduction: This article will guide you through completing the Setup of your SumUp Air Card Reader, within your talech Register system.
Before proceeding, please make sure that you have the following:
- Current talech Register app downloaded onto your iPad.
- Admin level access to the talech Register app itself.
- Complete the initial setup of your Card Reader.
This article applies to any with the following criteria:
Register Type |
Region |
Talech Tier |
Business Type |
|
|
|
|
Table of Contents:
- Connecting your Sum Up Air
- Performing a test transaction
Connecting your Sum Up Air:
Step 1: Log into the talech app using either the email address and password combination, or your admin’s 6 digit PIN.
Step 2: Select Dashboard in the top right hand corner,
Step 3: Chose Back Office.
Step 4: Select Settings.
Note: Remain in the General Settings and scroll down to the Payments Section.
Step 5: Select the Card Reader option
Step 6: Select the SumUp option. The selection will be saved automatically.
Note: If this was previously set as the card reader, it should already be selected for you. If not simply select it again.
Performing a Test Transaction:
Once you have selected your card reader in the settings, we recommend performing a test transaction to make sure that the connection is complete and that you are able to process cards with no issues.
Below are the Step by Step instructions that will show you "How to perform a test Transaction".
Step 1: Navigate back to the Card Reader settings following the steps provided above.
Step 2: Once you see the list of card readers, select the Blue Test Payment button at the bottom of the page.
Then generate a test charge for £1, or €1, and connect to your card reader. You can then complete the payment on the reader as normal.
Comments
0 comments
Article is closed for comments.